Air Conditioner installation issue? - home thermostat installation
A new house built. 1450sqft, 9 'ceilings, 450sqft bonus room above the garage. Since the move can not be the work of CA, as I should.
In front of the house to the east, west. Under the present set time, the sun behind the house at noon, and not to 730 or 8.
The sunny days, the temperature will be higher than 130 loft. Penthouse is equipped with 24 "blown insulation and have 5 passive roof vents on the back of the house.
CA is installed in the attic, the fan and fan.
On cold days, everything works well when the attic temperature of 100 or less. Hot days ... have a problem.
The thermostat is in the hall, scheduled for 77th Home to 6 clock on a sunny day will come when the thermostat reads 81st It works, but not cool. Only cools in the evening.
During the day, a bonus room heated to 85th Thermostat, but 77, as below, so that it does not work.
N Kow, what is the size of the AC .. Find out.
They do not know if I need more unity. I think I need more attic ventilation to reduce the heat around the AC unit
Wednesday, December 23, 2009
Home Thermostat Installation Air Conditioner Installation Issue?
4 comments:
Who will install this device has properly adjusted calculations. All the things you have mentioned, there are considerations to calculate the size of the unit (in tonnes) of the compressor and the evaporator and condenser. There is software that can check for you. Google software for the calculation of the CVC.
Who will install this device has properly adjusted calculations. All the things you have mentioned, there are considerations to calculate the size of the unit (in tonnes) of the compressor and the evaporator and condenser. There is software that can check for you. Google software for the calculation of the CVC.
The first figure out what to do, to which A / C unit is in tons of refrigeration. Not to say closer to the disc label, but he said that thousands of BTU. Ie, 30,000 BTU is a 2 1 / 2 Ton to be installed at home. My attic is hot at 130 degrees, but should not affect System A / C system refrigerant C higher than the A talk / use pipes made of copper pipes or tubes, depending on you. A system A / C works fine ... Heat (hot air) in your home is "taken" by the coil in your furnace supply complete by the fan. Exccess that heat is pumped through the lines to the outdoor coil and as tthru running outside the house to get rid of heat through the condenser fan at the top of the camera. This is the basic understanding of how a unit of A / C works well Residentail or Commercial Matters. I would say that unless the contractor installs the heating / cooling your home is not loading correctly or the system is too small. These are just 2 thingswhat could be wrong, but these are the first things I check on.
Sounds 3 a.m. to 1 p.m. / 2 is probably the maximum that can be description.Look are described in the model # of your unit.They outdoors as in # 12,000 BTU per BTU ton.You seen in # 36 for a device 3, and I tons am sure that what have.Check that out.42 3 a.m. to 1 p.m. / 2-ton unit.
I like to remove the indoor unit to 1 / 2 ton only to the latent heat and let cool slightly.
It could not call in a hundred other things like the problems with your though.Keep device an eye on him and a service, if necessary, take place.
Post a Comment